Bully Dog 4038x Sensor Docking Station - Manual (Page 18)

17
Sensor Docking Station
7. Attach the power harness ground connections.
a. Fasten the black chassis ground wire to the vehicle
frame.
• Use the designated ground bolt.
• If the designated ground bolt is not available, use a
stock frame bolt.
b. Fasten the white battery ground wire to the negative
battery terminal.
8. Connect the power harness to the fuse box.
a. Remove the key-on fuse that you located during Set Up
(see page 15).
b. Slide the fuse tap over one metal prong on the fuse.
c. Slide the spade (that is attached to the power wire) over
the fuse tap.
d. Put the fuse back in the fuse box.
9. Connect the power harness to the Sensor Docking Station.
a. Apply a reasonable amount of dielectric grease on the
power harness plug. (Apply the grease to the electric
connections on the plug.)
b. Insert the power harness plug into the power port on
the Sensor Docking Station.
• (The power port is labeled PWR.)