Sensor docking station, Tools needed, Recommended sensors – Bully Dog 4038x Sensor Docking Station User Manual
Page 4
3
Sensor Docking Station
40385
(O
2
sensor support - Pyrometer not included)
Sensor Docking Station
O
2
Support and Power Harness
.....(
4-40385
)
Ring Terminal .......................................................(
40383-4
)
Fuse Tap ...............................................................(
40400-20
)
Spade ...................................................................(
40400-21
)
Dielectric Grease ..................................................(
40383-3
)
2″ Square Hook and Loop Fastener .....................(
40390-94
)
Zip Ties (6)............................................................(
1-NYTIE6
)
Tools Needed
(Italic tools are required only for pyrometer installation)
• Crimpers
• Drill
• 5/16″ Drill Bit
• 1/8″ Pipe Tap
• 9/16″ Wrench
• 5/8″ Wrench
Recommended Sensors
• Additional Bully Dog Pyrometer
• Three-wire analog sensor
• Two-wire frequency pulse sensor
• Two-wire 0-5 volt temperature sensor