Bully Dog 4038x Sensor Docking Station - Manual (Page 23)

22
Sensor Docking Station
Sensor Setup and Calibration
Pyrometer Wiring
There are two openings on each pyrometer docking port. Plug
the yellow wire into the Y+ opening. Plug the red wire into the
R- opening.
(Reminder: The pyrometer connection consists of a short length of bare
wire on the end of each cable. To plug in the pyrometer, or any sensor,
simply insert the bare wire end straight into the dock opening. An internal
mechanism will clamp down and hold the wire in place.
)
IMPORTANT NOTE: All Light Duty GTs and WatchDogs must be updated to software
version 1.1.4.0 or later to work properly with the Sensor Docking Station. All
Heavy Duty GTs and WatchDogs must be updated to software version 1.0.3.6 or
later to work properly with the Sensor Docking Station.