Calculated Industries QFCCL - Manual (Page 19)

P
OCKET
R
EFERENCE
G
UIDE
— 15
Press Result
1 Sashing Yardage
2 Number of Strips
(to cut for the Sashing)
3 Sashing Strip Cut Width
Note: Sashing is calculated, by default, to
include Sashing surrounding the perimeter of the
Blocks (see Preference Settings for details) in
addition to the Sashing between Blocks. You may
select not to include the Sashing surrounding the
Blocks and only calculate the Sashing between
Blocks (see figure below). See Preference
Settings for how to change this Sashing
Preference Setting.
b
Consecutive presses of this key
calculate:
Press Result
1 Total Block Yardage
2 Number of Blocks
3 Number of Strips
4 Block Strip Cut Width
5 Total Sashing Yardage*
6 Number of Strips
(to cut for the Sashing)*
7 Sashing Strip Cut Width*
Note: Continued presses of b will repeat
above sequence.
*Sashing values do not display if Sashing is zero.
Note: Entries of Block size, number of Blocks across,
number of Blocks down, and Sashing are semi-
permanent entries; that means, they do not clear until
you turn off your calculator or until you enter a new
value. You can enter zero for Sashing if you do not
want Sashing included in the Block Yardage calcula-
tion.