Calculated Industries 6414 - Manual (Page 44)

Error Codes
When an error occurs, the display will show one of the fol-
lowing messages:
Error 1 Attempt to enter a wheel ratio of 0%
Error 2 Attempt to add values of unlike dimensions in memory
Error 3 Attempt to move a current room with 0 length, 0 width,
and non-zero height into the area key
nonE Attempt to enter fixed distance or autocount mode with
zero (0) stored in the fixed distance key
Lo bAtt Low battery power
FULL Attempt to move measurement(s) into the Area Number
registers but all Area Number registers are full
OFLO Attempt to display a value too large for display
Most errors can be cleared by pressing the [RESET] key.
42 – DigiRoller/DigiRoller Plus ™