Calculated Industries 6414 - Manual (Page 7)

Area Key — Calculates and displays rolled area.
Units of Measurement Key — Selects desired unit for-
mat: Feet-Inches, Decimal Feet, Decimal Inches,
Yards, Meters, and Acres (display only). Each press
of this key will convert the displayed measurement
to another unit format.
Delete/All Clear Key — Deletes, or erases, the values
stored in the next key pressed (e.g.,
[DEL] [L] deletes
the current measurement stored as length, [DEL]
[ W ] deletes the current measurement stored as
width, etc). To perform an All Clear, press [Set]
[DEL] [DEL]. This key sequence will clear all stored
data and memory registers.
Recall Key — Recalls and displays the value of the
next key pressed (for example,
[Rcl] [W] displays
the value stored in the Width key). [Rcl] [Rcl] will
bring back or un-erase a previously displayed value
that has been cleared or deleted.
Memory Add Key — Stores any displayed value into
permanent memory. When you store a value in
memory, it is added to the values you previously
stored in memory. Note that you cannot add two
measurements of unlike dimensions (for example,
you cannot add feet-inches and square feet).
5 – User’s Guide