Calculated Industries 6414 - Manual (Page 8)

Memory Subtract Key — Subtracts the displayed
value from permanent memory.
Set Key — Used to access special functions.
Add Wheel Radius Key — Adds the radius measure-
ment of the wheel to the total linear measurement,
to allow for true wall-to-wall distance.
Reset/Clear Display Key — Clears the display to 0.
Does not clear stored values.
Start/Stop Key — This key switches the unit between
start and stop modes. You will press this key to
begin measuring. When you are in stop mode, a stop
sign annunciator will display and the unit will stop
measuring. Press
[Start/Stop] or [RESET] to resume
measuring.
Manual Count Key — Each time you press this key,
the unit will show the count in the upper left of the
display. The unit will count from 1-199, and then
will roll over and continue counting from 1.
However, if you press [Rcl] [Count], the accumulat-
ed total will display (for example, 203) on the right
side of the display.
6 – DigiRoller/DigiRoller Plus ™