Sew-light, To change the bulb, Swing open face plate – Brother 681B-UG User Manual
Page 13: Remove bulb by turning counter-clockwise, After replacement, close the face plate, Note, Presser foot, To remove the presser foot, Raise needle to its highest position, Raise presser foot
Advertising
Sew-Light
To change the bulb:
1. Swing open face plate.
2. Remove bulb by turning counter-
clockwise.
3. After replacement, close the face plate.
NOTE:
1. Make sure new bulb is the same
specification as old one.
2. Make sure to switch off the light and
pull out supply plug when you replace
the bulb in order to avoid electric
hazards.
Presser Foot
To remove the presser foot;
1. Raise needle to its highest position.
2. Raise presser foot.
3. Loosen presser foot thumb screw and remove presser
foot.
4. To attach the presser foot, place grooved side of the
foot against the flat of the presser bar.
5. Tighten thumb screw.
-11-
Advertising