Operating your sewing machine, Connecting plugs, First connect three-prong plug in socket – Brother 681B-UG User Manual
Page 7: Then connect electric supply plug into wall, Caution, When changing needle, bobbin or light bulb, Or when sewing machine is not use, it is, Recommended that electrical supply plug, Is disconnected to avoid electrical hazards
Advertising
Operating Your Sewing Machine
CONNECTING PLUGS
1. First connect three-prong plug in socket.
2. Then connect electric supply plug into wall.
CAUTION
When changing needle, bobbin or light bulb,
or when sewing machine is not use, it is
recommended that electrical supply plug
is disconnected to avoid electrical hazards.
Place foot on control pedal as shown in
illustration at left.
When foot controller is pushed down lightly,
machine will run at a low speed.
When pressure on foot is increased, sewing
machine will pick up speed.
When foot controller is released the sewing
machine will stop.
NOTE: Care should be taken that nothing is
placed on foot controller when
sewing machine is not in use.
-5-
Advertising