Brother 681B-UG - Manual (Page 29)

EMBROIDERING, USING EMBROIDERY HOOP
SET YOUR SEWING MACHINE AS PER FOLLOWING TABLE.
1. Remove presser foot.
2. Draw design on the material.
3. Use embroidery hoop as you would for
monogramming.
4. Position the hoop under the needle and
lower presser bar.
5. Pull lower thread up through material.
6. Stitch outline of design by removing
embroidery hoop accordingly.
7. To fill in design stitch from outline of
design to inside and from inside to edge
of outline alternately until design is
completely filled in. Keep stitching close
together.
NOTE: A long stitch is made by removing
embroidery hoop rapidly and a short
stitch is made by moving it slowly.
-27-