Metrohm IC Net 2.3 - Manual (Page 162)

6 Devices
IC Net 2.3 152
Third column Parameter for program instruction (see be-
low).
ENABLED Enable program start (a disabled program
is not started).
<Add> Add new program instruction.
<Delete> Delete selected program instruction.
<Verify> Test the time program (error messages are
displayed if program is wrong).
List of program instructions
The following program instructions can be added to the time pro-
gram on the
Program page:
Instruction Parameter entry Meaning
Program RESET, END Set program flag. The END flag
can be used to end a program,
especially if the program time
should be longer than the chro-
matogram duration . Additional
steps after this flag are not al-
lowed. The RESET flag is used to
reset the parameters to the sys-
tem startup values.
Pump on, off Switch on or off the pump drive.
Links
The Links tab of the 754 Dialysis Unit is used for Event line selec-
tion.