Metrohm IC Net 2.0 - Manual (Page 180)

10 Batch reprocessing
IC Net 2.0 172
bration parameters (component table, con-
centration table and calibration curve) are
applied to all sample runs.
Apply final calibration to all reprocessed files
Apply the updated calibration to all calibra-
tion and sample runs. If this option is
switched off, the calibration stored in the
first chromatogram is used for all other
chromatograms.
Forget calibration points before reprocessing
Forget old calibration points of the calibra-
tion curve and perform a new calibration
using all calibration runs of the batch re-
processing queue. In this case each cali-
bration chromatogram adds a new point to
the calibration curve. If this option is
switched off, the calibration curve stored in
the first chromatogram remains active.
Each further calibration chromatogram in
the batch reprocessing queue adds a new
point to this calibration curve.
Recalculate only Enable recalculation of chromatograms
with values for Volume , Dilution , Amount and
Internal standard amount entered in the batch
reprocessing table.
The recalculation is done automatically if
the
Reintegrate and/or Recalculate options
are enabled. If the Recalculate only option
is enabled, the Reintegrate and Recalculate
options are disabled automatically.
Change passport If this option is enabled, those parameters
of the passport which have been changed
after clicking the <Edit passport> button are
applied to all chromatograms.
<Edit passport> Open the Passport window for modification
of the passport parameters.
Only some of the passport parameters
can be modified. The passport parame-
ters
Ident , Sample Info 1 and Sample Info 2
entered in the batch reprocessing table
are overwritten if these values are modi-
fied in the
Passport window.