Metrohm IC Net 2.0 - Manual (Page 29)

4.3 System functions
IC Net 2.0 21
SYSTEM / Control / Disconnect from workplace
Disconnect selected system from the workplace. If a system is
disconnected, manual control is not available for this system, but
all other system settings can be modified and saved. Start deter-
mination and Startup hardware is only possible if no other system
from the same system folder is connected. In this case, the sys-
tem is automatically connected.
4.3.2 Start/stop hardware and record baseline
SYSTEM / Control / Startup hardware (Measure Baseline)
With this menu item the following actions are executed automati-
cally:
• Send System startup values to the devices.
• Start Metrohm solvent delivery systems and Bischoff solvent
delivery systems.
• Start Metrohm additional modules and Bischoff additional
modules.
• Start Bischoff detectors.
• Switch Metrohm Autosamplers and Bischoff Autosamplers to
remote control.
• Start recording of the measurement signal using the method of
the connected system. Independently of the set chromatogram
Duration
, the measurement signal is recorded until the data
acquisition is stopped if a new determination is started with
Start determination or by clicking the icon of the chroma-
togram window. In this case the user is asked if the recorded
baseline should be saved or not.
SYSTEM / Control / Shutdown hardware
With this menu item the devices are stopped as follows:
• Stop Metrohm solvent delivery systems and Bischoff solvent
delivery systems.
• Stop Metrohm additional modules and Bischoff additional
modulesVariotherm.
• Stop Bischoff detectors.
• Switch Metrohm Autosamplers and Bischoff Autosamplers to
local control.
• Stop running determination.
• Stop active sample queue.
SYSTEM / Control / Stop data acquisition
Stop recording of the baseline.