Metrohm 864 Robotic Balance Sample Processor - Manual (Page 50)

3.14 Connections ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
42 ￭￭￭￭￭￭￭￭ 864 Robotic Balance Sample Processor
3 Fasten the ionizing bar
￭ Fasten the ionizing bar to the holder as shown in the preceding
illustration and fix it in place with the two accompanying hexagon
nuts.
4 Connect the cables
￭ Connect the cable of the ionizing bar to the control device.
￭ Connect the control device to the mains supply.
Note
The ionizer must be switched on by hand before a determination ser-
ies.
3.14 Connections
The following figures show all necessary cable and tubing connections as
an overview.
3.14.1 Tubing connections
T1 T2
864 809
800
800
843
S W
P1
P2
S
T P
1 2
3
4
5
6
7
Figure 27 Tubing
1 Waste
6.1812.000 PTFE tubing.
Waste canister W — 843 pump 2
2 Solvent
6.1812.000 PTFE tubing.
Supply canister S — 843 pump 1
3 Aspiration tubing
6.1812.000 PTFE tubing.
843 pump 2 — 864 distributor, connector
on the right
4 Rinsing tubing
6.1812.000 PTFE tubing.
843 pump 1 — 864 distributor, connector
on the left