Metrohm 847 Lab Link - Manual (Page 26)

2 Installation
• Messages
When working with the Titrando system errors could occur (e.g. the defined
stirrer is not connected). The Touch Control indicates this with a message.
With the 847 USB Lab Link you have the possibility of sending such mes-
sages (all warnings with the symbol and error messages with the symbol
) as e-mails.
1. Open the corresponding dialog with [Messages] .
2. Activate the checkbox E-Mail to send messages as e-mails.
3. Send only when system is busy: if you activate this checkbox then
messages will only be sent when a determination run has been started,
i.e. when the system is in operation ("busy").
4. Confirm the alterations with [Back] .
Note
The sender and receiver of the e-mail and the e-mail server are defined
under Lab Link Server (see p. 28).
22 847 USB Lab Link / Lab Link Server