Metrohm 874 USB Oven Sample Processor - Manual (Page 40)

3.15 Connecting MSB devices ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
32 ￭￭￭￭￭￭￭￭ 874 Oven Sample Processor
USB 1 Contr. MSB 2 MSB 3
T.2400.102
Figure 19 Connecting a dosing device
3.15.2 Connecting a stirrer or titration stand
You can use a magnetic stirrer 801 Stirrer or 803 Ti Stand (stirring "from
below") or the 804 Ti Stand with a rod stirrer 802 Stirrer (stirring "from
above").
Connect a stirrer or a titration stand as follows:
1 Connect a stirrer or titration stand
￭ Exit the control software.
￭ Connect the connection cable of the magnetic stirrer or of the
titration stand to one of the sockets marked with MSB on the
rear of the control instrument.
￭ If desired, connect the rod stirrer to the stirrer socket (with stirrer
symbol) of the titration stand.
￭ Start the control software.
USB 1 Contr. MSB 2 MSB 3
Figure 20 Connecting MSB stirrer