Metrohm 940 Professional IC Vario ONE/HPG - Manual (Page 29)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
940 Professional IC Vario ONE/HPG (2.940.1140)
￭￭￭￭￭￭￭￭ 21
Route the loose end into a waste container.
3.5.2 Connecting the leak sensor
Plugging in the leak sensor connection cable
The leak sensor connection cable is coiled up in the base tray.
1 Pull the leak sensor connection cable out of the base tray as far as
needed.
2 Plug the plug for the leak sensor connection cable into the leak sen-
sor connection socket (labeled Leak Sensor).
3.6 Column thermostat
The column thermostat ensures that the flow of eluent and the separation
column(s) are at a constant temperature. It is firmly sealed by the instru-
ment's smaller door and is well insulated. The capillaries are fed through
small recesses on the inner front edge, so that they do not get pinched
when the door is closed.
The column thermostat is completely connected. No installation work is
required.