Banner PresencePLUS BCR 1.3 Series - Manual (Page 11)

P/N 118000 rev. D
11
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
sensor
configuration
sensor
configuration
step 7 step 7
System Setup
Use the System Setup screen to change discrete I/O, the communication port, the product
change, the strobe output (for external lighting control), the trigger input, and to view
diagnostic information.
Save inspections to the Sensor or to a folder on the PC.
Provides: Operation Help
Installation Help
Lens Selection Help
Lighting Help
Error Codes
About (GUI Software version, Sensor
Firmware version, Hardware version,
Sensor’s physical address)
InputOutput Configuration Tab
NOTE: To select the polarity of the
outputs, set one of the four
I/O pins to an output.
TIPS
Use Help > About
in the GUI to look
up the software,
firmware,
and hardware
versions. The
information will
be helpful if you
call Banner for
support.