Britax Boulevard - Manual (Page 17)

15
Verify all connections are secure and that restraint
is stable. The restraint is secure when it cannot be
moved front-to-back or side-to-side more than
1” (2.5 cm.) at belt path. If the restraint is not
secure, repeat procedure or use an alternate seating
location.
Britax recommends use of the Versa-Tether® to
improve installation. See pages 23-26.
The back angle of the child restraint should be 30º-
45º from vertical (not to exceed 45º from vertical)
when car is parked on a level surface (fig. G).
The proper recline angle can be achieved by placing
a rolled towel or pool noodle in crease of vehicle seat
to help level child restraint’s base.
If there is a problem stabilizing restraint, tighten tether
as described on page 24 using anchor point 3.
Removal
Disconnect the Versa-Tether from tether
anchor, if attached. While pushing the restraint
firmly into the vehicle seat, release the lock-off
and vehicle belt.
8�
•
•
•
•
Installation: Rear Facing
E
F
G
WARNING!
Do not raise restraint
off front edge of vehicle seat. Doing so
will reduce protection for your child
and may damage recline adjustment.