Britax Boulevard - Manual (Page 19)

17
I f your vehicle is equipped with an automatic locking
retractor (ALR), use of lock-offs is not required as
long as ALR is activated. Check your vehicle’s owner’s
manual to determine type of retractor your vehicle
has, and for proper use of retractor.
Verify all connections are secure and that restraint
is stable. The restraint is secure when it cannot be
moved front-to-back or side-to-side more than 1”
(2.5 cm.) at belt path. If the restraint is not secure,
repeat procedure or use an alternate seating
location.
Britax recommends use of the Versa-Tether® to
improve installation. See pages 23-26.
The back angle of the child restraint should be 30º-
45º from vertical (not to exceed 45º from vertical)
when car is parked on a level surface (fig. F).
The proper recline angle can be achieved by placing
a rolled towel or pool noodle in crease of vehicle seat
to help level child restraint’s base.
If there is a problem stabilizing restraint, tighten tether
as described on page 24 using anchor point 3.
Removal
Disconnect the Versa-Tether, if necessary.
While pushing the restraint firmly into the
vehicle seat, release the lock-off and vehicle
belt.
•
8�
•
•
•
•
Installation: Rear Facing
D
E
F
WARNING!
Do not raise restraint
off front edge of vehicle seat. Doing so
will reduce protection for your child
and may damage recline adjustment.