Ab c warning – Britax Boulevard User Manual

Page 18

Advertising
background image

16

Figure A illustrates a typical rear-facing, lap-belt

installation.

When not in use, always store LATCH connectors

in storage slots. (See page 28).

Fully recline restraint, then place it rear

facing on vehicle seat.

Lift cover and open rear-facing lock-off

farthest from where vehicle belt will be

buckled. (fig. B)

Pull vehicle belt out, then pass it through

farthest rear-facing belt slot from where

vehicle belt will be buckled (fig. C).

The vehicle belt can be routed over or under

restraint cover.

Route vehicle belt across restraint seat

then through second rear-facing belt slot.

Verify vehicle belt is not twisted, then

buckle (fig. D).

Push child restraint firmly into vehicle seat

while removing slack from vehicle belt.

Position vehicle belt through lock-off arm

(fig. E), tighten belt, close lock-off arm

and replace cover.

Lock-off is properly closed when a click is

heard.

To prevent breakage, never extend lock-off arm

beyond its natural open position and always

keep lock-off closed when not in use.

1�

2�

3�

4�

5�

6�

7�

Lap-Belt Installation

Installation: Rear Facing

A

B

C

WARNING!

Do not install with non-locking (ELR),

2-point vehicle belt.

Advertising