E-flite Mini Pulse XT PNP - Manual (Page 11)

11 E-flite Mini Pulse PNP Assembly Manual
 2. Slide the 1/2" (13mm) washer onto the adapter.
 3. Slide the spinner backplate onot the adapter. Thread
the propeller nut onto the adapter, but do not tighten it
at this time.
 4. Install the propeller assembly onto the motor shaft.
Tighten the propeller nut using a hex wrench slipped
through the hole in the propeller nut.
Note: Make sure to check the balance of the propeller
after enlarging the hole in the propeller.
 5. Snap the spinner cone onto the spinner.