E-flite Mini Pulse XT PNP - Manual (Page 8)

8 E-flite Mini Pulse PNP Assembly Manual
Safety, Precautions, and Warnings
As the user of this product, you are solely responsible for
operating it in a manner that does not endanger yourself
and others or result in damage to the product or the property
of others.
Carefully follow the directions and warnings for this and any
optional support equipment (chargers, rechargeable battery
packs, etc.) that you use.
This model is controlled by a radio signal that is subject to
interference from many sources outside your control. This
interference can cause momentary loss of control so it is
necessary to always keep a safe distance in all directions
around your model, as this margin will help to avoid collisions
or injury.
• Always operate your model in an open area away from cars,
traffic, or people.
• Avoid operating your model in the street where injury or
damage can occur.
• Never operate the model out into the street or populated
areas for any reason.
• Never operate your model with low transmitter batteries.
• Carefully follow the directions and warnings for this and any
optional support equipment (chargers, rechargeable battery
packs, etc.) that you use.
• Keep all chemicals, small parts and anything electrical out of
the reach of children.
• Moisture causes damage to electronics. Avoid water exposure
to all equipment not specifically designed and protected for
this purpose.
Landing Gear Installation
Required Parts
Fuselage
Main landing gear
Wheel pant (L&R)
2" (50mm) wheel (2)
4-40 x 1/2" socket head bolts (2)
#4 black washers (2)
4-40 nut (2)
4-40 locknut (2)
4-40 x 1 1 /
4
" socket head bolts (2)
#4 steel washers (4)
2mm x 6mm wood screws (2)
Required Tools and Adhesives
Hex wrench: 3/32"
Phillips screwdriver (small)
Nut driver: 1/4"
Needle-nose pliers
Note: You may consider using a larger diameter wheel,
such as 2 1 /
4
" (58mm), if your flying site has rough
terrain. By using a larger wheel, you will not be able to
use the included wheel pants.