E-flite Mini Pulse XT PNP - Manual (Page 14)

1 E-flite Mini Pulse PNP Assembly Manual
Final Assembly
Required Parts
Fuselage
Wing
Receiver
Battery
Battery hatch
4-40 x 1" socket head bolt (2)
#4 washer (2)
Hook and loop tape
Hook and loop strap
Required Tools and Adhesives
Hex wrench: 3/32"
 1. Plug in the elevator and rudder servos and ESC
into the receiver. Mount the receiver to the inside of the
fuselage using hook and loop material. Route the antenna
wire through the bottom of the fuselage to the rear, or as
directed by your radio instruction manual.
Note: Do not cut or change the length of the antenna
wire, as this will reduce the range of your radio system.
 2. Plug the Y-harness for the aileron servos into the
receiver. Attach the wing to the fuselage using two
4-40 x 1" socket head screws and two #4 washers.