E-flite Mini Pulse XT PNP - Manual (Page 12)

1 E-flite Mini Pulse PNP Assembly Manual
Tail Installation
Required Parts
Fuselage
Rudder/Fin
Stabilizer/Elevator
2mm x 4mm screw (2)
4-40 locknut (2)
#4 washer (2)
Linkage wire, 4" (102mm) for elevator
Linkage wire, 5 1 /
2
" (140mm) for rudder
Required Tools and Adhesives
Nut driver: 1/4"
Screwdriver, #0 Phillips
 1. Locate the stabilizer/elevator assembly. Position the
stabilizer/elevator assembly so the control horn will face
down, away from the fin. The threaded rods from the
rudder/fin assembly will slide into the two holes in the
stabilizer.
 2. Slide the rudder/stabilizer assembly onto the fuselage.