GBC 64Ct - Manual (Page 19)

Page 5-5
SPIRE III Series – Installation and Operating Instructions
s
HaFt
s
toraGe
c
radle
Figure 13. Shaft Storage Cradle on Back of the Laminator.
Use Shaft Storage Cradles to store shafts that are
not in use.
p
ull
r
ollers and
c
HIll
I
dler
(44t, 64t)
Figure 14. Pull Rollers and Chill Idler.
Shown from rear.
WARNING: Keep your hands and fingers
away from the point between the two Main
Rollers (nip point) and Pull Rollers. Do not operate
when alone. More than one person is required to be
in the area when operating. Failure to observe this
warning could result in severe personal injury.
If entrapment between the Main or Pull Rollers
occurs, use an Emergency Stop Switch.
Emergency Stop Switches
The Emergency Stop Switches are located on all
four upper corners of the machine.
Pull Rollers raise and lower with the Main Rollers by
turning the Gap/Pressure Crank.
a p
ull
r
ollers
(44t, 64t)
The Pull Rollers are motor driven and are located at
the back of the laminator. The rollers pull the film and
image through the laminator.
c. c
HIll
I
dler
The Chill Idler is located between the Main and Pull
Rollers. While film or media is exiting through the
Main Rollers, the Chill Idler cools the media as it
exits the Main Rollers.
c
oolInG
F
ans
(44t, 64t)
Located behind the Main Rollers, the fans cool the
web as it exits the heated rollers.
Figure 15. Cooling Fan Ports.
Shown from rear; Pull Roller in foreground.