GBC 64Ct - Manual (Page 6)

SPIRE III Series – Installation and Operating Instructions
Page 1-2
WARNING
WARNUNG
MUCHO
CUIDADO
ATTENTION
RISQUE DE
BROYEMENT.
Tenir mains et
vêtements a l'écart
RIESGO DE
PINCHAMIENTO.
Mantener las manos
y prendas de vestir
a distancia.
CRUSH HAZARD
Keep hands and
clothing away from
rollers.
QUETSCHGEFAHR.
Hände und
Kleidung fernhalten.
WARNING
WARNUNG
This safety notice means
that your fingers and
hands could be trapped
and crushed in the rollers.
Clothing, jewelry and long
hair could be caught in the
rollers and pull you into
them. Keep fingers, hands
clothing, jewelry, and long
hair away from the rollers.
This safety notice means that
your fingers and hands could
be trapped and crushed in the
gear and chain. Clothing,
jewelry and long hair could be
caught in the gear and chain
and pull you into them. Keep
fingers, hands clothing,
jewelry, and long hair away
from the gear and chain.
WarnInGs
• Do not attempt to service or repair the
laminator.
• Do not open the laminator. There are no
serviceable parts inside. Refer service to
qualified service personnel.
• Do not connect the laminator to an electrical
supply or attempt to operate the laminator
until you have completely read these
instructions. Maintain these instructions in a
convenient location for future reference.
• Entrapment hazard. Do not operate when
alone. More than one person is required to be
in the area when operating the machine.
• To guard against injury, the general safety
precautions must be observed when installing
and using the laminator.
• Consider the work area. A cluttered work area
can lead to accidents. The laminator must be
placed on a sturdy level floor surface. Allow
sufficient access to the front, back, and sides
of the laminator. Keep the work area well lit.
Failure to observe these warnings could result in
severe personal injury or death.
c
autIons
Caution indicates a hazardous situation which, if not
avoided, could result in minor or moderate injury or
cause damage to the machine.
G
eneral
• Keep fingers, hands clothing, jewelry, and long
hair away from the front of the rollers to avoid
entanglement and entrapment.
• Do not use the laminator for other than its
intended purposes.
• Avoid quick stops, excessive force and uneven
floor surfaces when moving the laminator.
• Do not defeat or remove electrical and
mechanical safety equipment such as
interlocks, shields and guards.
• Do not insert objects unsuitable for lamination
or expose the equipment to liquids.