GBC 64Ct - Manual (Page 24)

SPIRE III Series – Installation and Operating Instructions
Page 5-10
c
ontrol
p
anel
The Control Panel is located on the right side of the
machine and controls all operations of the machine.
A B C D
E
F
Figure 27. Model T Control Panel shown.
The following elements apply to all models.
a. stop
Press to stop the rollers. The LEDs above the buttons
illuminate to indicate which function is selected.
B. run
Press to run the rollers at the selected speed.
c. rev
When this button is pressed and held, the rollers will
rotate at 3 ft./minute in reverse. Once the REV button
is released, the Rollers will stop rotating in reverse.
d. Fan (44t, 64t)
Press to turn on the fans and press again to turn
off the fans. The Fans only run when the motor is
rotating. When
FAN is pressed, the LED turns on,
but the fans only function when the motor is rotating.
When the motor stops rotating, the fans also stop.
e. pressure
LEDs illuminate to indicate the amount of pressure
between the Main Rollers.
F. s
peed
c
ontrol
k
noB
Turn to increase or decrease the roller speed.
Rotate clockwise to increase speed. Rotate
counterclockwise to reduce speed. The range is 1
to 10 and the maximum speed is 20 ft. (6 meters)
per minute. The display indicates the set speed.
The display flashes when using the Footswitch to
indicate an override of the Photo Safety Sensor and
the Interlock on the Feed Table. Refer to the “A.
Photo Safety Sensor” and “Raising the Feed Table”
sections.
m
odel
44t, 64t c
ontrol
p
anel
e
lements
The 44T and 64T models include the above items
and controls for the top roller. The top roller controls
operate the same as the Lower roller controls.
B
C
A
D
Figure 28. 44T, 64T Control Panel Elements.