GBC 64Ct - Manual (Page 29)

Page 6-3
SPIRE III Series – Installation and Operating Instructions
Figure 35. Shaft slot indicator.
3. Lift the driven end of the shaft out of the Saddle,
and then pull the shaft out of the opposite
Saddle.
4. Slide the roll of film onto the film shaft, ensuring
the adhesive does not make contact with the
roller.
5. Insert the film shaft back into the film shaft
Support Saddle.
6. Push the clevis pin through the holes in the
Support Saddle.
Figure 36. Shaft Clevis Pin in the Support Saddle.
7. Center each supply roll on the shafts using the
rulers on the shafts.
Refer to “Film Alignment”.
W
eBBInG tHe
m
acHIne
Prior to webbing the machine, ensure the supply
rolls are centered on the shafts. Also make sure to
remove all brake tension on the unwind and supply
shafts before you begin.
WARNING: Rollers may be hot. Hot rollers
could burn you. Take care not to touch rollers while
removing, loading, or changing film.
Caution: Press STOP to ensure the machine is not
running.
Note: Depending on the model of your laminator and
its version, the photos in this guide may not look like
your laminator. However, webbing the machine is the
same.
To web the machine:
1. Guide the top film under the Idler and back up to
the rewind tube.
Figure 37. Pulling pressure sensitive adhesive (PSA) film to
the Rewind Tube.
2. Fasten the center of the film to the to the rewind
tube with tape.