GBC 64Ct - Manual (Page 37)

Page 6-11
SPIRE III Series – Installation and Operating Instructions
9. Press the Footswitch.
10. As the materials feed into the rollers, pull the
release liner off the substrate.
11. Continue until the graphic and substrate exits the
rollers.
t
Ips
• For larger graphics, a second person at the
back of the laminator can help apply tension
to the graphic. This frees up the person in the
front of the laminator to clean up materials and
handle the release liner.
• If the release liner gets caught in the rollers,
stop the laminator and reverse the materials
out of the rollers until you can pull out the
release liner.
• Do not allow the materials to stop under
the pressure of the rollers for any extended
time. This can cause indentations on softer
substrates.
t
Hermal
l
amInatIon
Use this process to encapsulate images between
two thermal films.
Examples include menus, posters, and photos.
NOTE: In the following illustration, Pull rollers are
required.
P
P
MR
MR
R
R
U
U
R
Figure 52. Thermal lamination diagram.
To laminate an image:
1. Press
STOP.
2. Load a roll of thermal laminate on the top Unwind
roller.
3. Load a roll of thermal laminate on the bottom
Unwind roller.
4. Pull the top laminate under the Idler toward the
front of the laminator and then drape it over the
top Main Roller.
5. Remove the Pressure Plate.
Refer to the “Removing the Pressure Plate”
section.
6. Raise and secure the Feed Table.
7. Pull the bottom laminate behind the bottom Idler
and back up to the Main Rollers.
8. Line up the edges of the two laminates and
attach them together.
9. Lower the Main Rollers just enough to make
contact with each other.
10. Lower the Feed Table and remove the Pressure
Plate.