GBC 27C - Manual (Page 14)

Operating Instructions
Page 5-2
27C
F
EED
T
ABLE
The feed table is used to position items for
laminating and mounting.
When the feed table is
removed, the laminator runs at 3 fpm (0.9 m)
when you press the RUN button. The feed table is
removed only when you load film.
T
ABLE
I
NTERLOCK
L
ATCH
Fig. 5-2. Table Interlock Latch Under the Table.
The interlock latch locks the feed table into position
and activates an interlock switch. The latch is located
on the left, underside of the feed table. Move the
latch to the right to release the table. Then lift the
table upwards and away from the laminator.
B
OTTOM
F
ILM
S
UPPLY
S
HAFT
Holds the film or kraft paper on the machine.
F
ILM
W
EB
(Not shown.) The path the laminating film and/or
mounting film mounted on the machine takes
through the machine.
C
ORE
A
DAPTORS
Fig. 5-3. Core Adaptors on the Shafts.
The core adaptors hold and lock the rolls of film
and release liner on the shafts to prevent side to
side shifting. Grippers on the supply shafts ensures
proper tension on the film. The supply shaft core
adaptors lock in place with a set screw. The release
liner take-up core adaptors are held in place by
friction.
R
OLLER
P
RESSURE
H
ANDLE
Fig. 5-4. Roller Pressure Handle.
The roller pressure handle adjusts the amount of
roller pressure needed for various laminating and
mounting applications. Pull the handle out of a
position, rotate it to the desired pressure, and press
it into the slot. Three main function settings are
provided.
Table interlock latch
Supply shaft
Take-up shaft
Core adaptor
Gripper
Roller pressure
handle
Settings