GBC 27C - Manual (Page 29)

Page 7-1
Operating Instructions
27C
C
ARING FOR THE
27C L
AMINATOR
The only maintenance required by the operator
is to periodically clean the rollers. The following
procedure will help keep them free of dirt and
adhesive, which has been deposited along the edge
of the laminating film. Proper alignment of the rolls of
film reduces the amount of adhesive on the rollers.
Perform only the routine maintenance procedures
referred to in these instructions.
WARNINGS:
Do not attempt to service or repair the laminator.
Do not apply any cleaning fluids or solvents to the
rollers. Some solvents and fluids could damage
the rollers.
Keep fingers and hands away from the rollers
when the machine is running. They could be
trapped and crushed in the rollers. Clothing,
jewelry, and long hair could be caught in the
rollers and pull you into them.
Failure to observe these warnings could result in
severe personal injury or death or damage the
machine.
C
LEANING
T
HE
R
OLLERS
Keeping the rollers clean ensures that your finished
items will not be damaged by dirt and adhesives.
You will a 3M™ Scotch-Brite™ pad and a clean rag
moistened with water and dish soap.
Never clean rollers with abrasive, sharp, or
pointed objects.
Do not use any other cleaning agents other
than those listed above.
Accumulated adhesive deposits on the rollers
can cause damage to the rollers. Rotate the
rollers at the lowest speed setting on the
control panel.
•
•
•
•
•
•
To clean the rollers and idler bar:
Remove the safety shield and feed table. Refer
to
Removing and Installing the Safety Shield and
Removing and Installing the Feed Table in the
Operation chapter.
Remove the film from the laminator. Refer
to
Loading Film Onto the Supply Shafts in the
Operation chapter.
Gently rub the top and bottom rollers with a
3M Scotch-Brite pad.
DO NOT USE METAL
SCOURING PADS! Do not use any abrasives to
clean the rollers.
Use the dampened rag to remove any dust, dirt,
and other foreign materials from the rollers.
Press and release the RUN button to rotate the
rollers to an unclean portion.
Keep your hands, fingers, pad, and rag away
while running the machine. Be sure to remove all
adhesive and dirt.
Install the feed table and safety shield.
1.
2.
3.
4.
5.
6.
7. O
PERATOR
M
AINTENANCE