GBC 27C - Manual (Page 26)

Operating Instructions
Page 6-10
27C
M
OUNTING
T
IPS
F
OR
T
HREADING
P
RESSURE
S
ENSITIVE
A
DHESIVE
(PSA) F
ILM
Use kraft paper for one-sided lamination.
Refer to Fig. 6-15. for the proper film
configuration.
Whenever possible, pull the remaining web
of film out the front of the laminator after the
finished item has been removed.
P
RE
-T
REATING
B
OARDS
You may wish to pre-coat mounting boards ahead of
time with PSA mounting film.
Fig. 6-17. Laminator Ready for Pre-treating Boards.
To pre-treat boards:
Load the laminator as shown in Fig 5-17.
Adjust the roller pressure handle to the proper
mounting setting.
Start a leader board into the rollers.
Press RUN.
Continue feeding one board after another.
Tip: Butt the leading edge of the next board to
the trailing edge of the previous one to ensure an
even application of film.
Press STOP when the last board exits the
machine.
•
•
•
1.
2.
3.
4.
5.
6.
M
OUNTING
O
NLY
This process requires a decalled item with PSA
mounting adhesive. Refer to the
To run the second
pass instructions in the Decaling In Two Passes section
of this chapter. An alternative method is to use a
PSA pre-treated board, which is described in the
Mounting and Overlamination section.
F
ILM
A
LIGNMENT AND
T
ENSION
F
ILM
A
LIGNMENT
The top and bottom supply rolls must be aligned
as closely as possible. Misalignment can cause
adhesives to be deposited on the rollers.
Fig. 6-18. Measuring Points.
To align the supply rolls:
Use a ruler to measure the distance between the
left edge of the roll to the side frame.
Measure the distance between the right side of
the roll to the side frame.
Shift the roll side to side to ensue that the two
measurements are equal.
1.
2.
3.
PSA mounting film
Board
Measure here