GBC 27C - Manual (Page 17)

Page 6-1
Operating Instructions
27C
This chapter describes how to use the laminator to:
Operate the machine
Load films (web the machine)
Laminate items
Mount items
G
ENERAL
O
PERATION
These instructions assume that the films have been
loaded. For information about loading films, see the
Loading Film section in this chapter.
Fig. 6-1. Control Panel.
To run the laminator:
Turn the laminator On (I) with the power switch
located at the back of the machine.
WARNING: Make sure the safety shield and
feed tray are in their proper positions. Your fingers
and hands could be trapped and crushed in the
rollers. Clothing, jewelry, and long hair could be
caught in the rollers and pull you into them.
•
•
•
•
1.
Set the roller pressure handle for the thickness of
the item that is to be laminated or mounted.
Fig. 6-2. Roller Pressure Handle.
Set the desired speed on the control panel.
Press the RUN button.
The rollers will begin to turn.
Position the item(s) to be laminated or mounted
on the feed table.
Push the item(s) squarely into the roller nip point
(where the two rollers meet). Additional items
can be laminated or mounted without stopping
and starting the machine.
Press the STOP button to stop the laminator
when all of the items have completely exited the
rear of the machine.
2.
3.
4.
5.
6.
7.
6. O
PERATION
RUN
STOP
REVERSE
min. max.
Speed
adjustment
STOP
button
RUN
button
REVERSE
button
LED