HCO SG550 - Manual (Page 20)

HCO 3-Advanced Setting SG550/SG530
Page 17
parameter only two values: On and Off. The default value is On.
1 Press the UP or DOWN key until “Time Stamp” appears, as shown in Fig. 14(a) and
14(1).
2 Press the RIGHT key to change the value to the desired value, as shown in Fig. 14(b)
and 14(2).
3 Press the OK key to save or MENU key to cancel and exit. After pressing the OK key,
the selected value will no longer be highlighted, as shown in Fig. 14(c) and 14(3).
(a) (1)
(b) (2)
(c) (3)
Figure 14: Setting time stamp
3.1.11 Timer
You can define a certain time period in a day when the camera can be triggered. In the rest of
the time the device is shut off. This function is only effective when the camera is in the LIVE
mode. The value of the hour ranges from 0 to 23 and the minute ranges from 0 to 59. The Start
and Stop time will only be effective when the timer is set to the value “On”.
1 In MENU, press the UP or DOWN key until “Timer Switch” appears, as shown in Fig.
15(a) and 15(1).
2 Press the RIGHT key to switch between “On” and “Off” of this function, as shown in
Fig. 15(b) and 15(2).
3 Choose “On” to proceed further settings. press the OK key, you will see “TIME LAPSE
SET”. The hour of Star time will be highlighted, as shown in Fig. 15(c) and 14(3).
4 Press the UP or DOWN key until desired hour appears, as shown in Fig. 15(d) and
15(4).
5 Press the RIGHT key to set minute of the Start time. The minute of Start time will be
highlighted, as shown in Fig. 15(e) and 15(5).
6 Press the UP or DOWN key until the desired minute appears, as shown in Fig. 15(f) and