HCO SG580M Manual - Manual (Page 15)

HCO ScoutGuard SG580M
4 Advanced Operations
Page 12
e) Press OK to save all current setting and return to info display.
Press MENU to cancel setting and return to info display.
4.1.8 Set Photo Burst
The following shows how to set photo burst to 3 Photo , provided that the
previous option is 1 Photo:
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Photo Burst.
c) Press LEFT or RIGHT to select 3 Images.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.
4.1.9 Set Video Length
Press LEFT or RIGHT to decreases or increases the value by 1 second.
The following shows how to set video length to 5 Seconds provided that the
previous value is 10 Seconds:
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Video Length.
c) Press LEFT or RIGHT to decrease or increase to 5 Seconds.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and exit.
4.1.10 Set Video Sound
The following shows how to set video sound as off that the previous option is on:
e) Press MENU to display the setting menu.
f) Press UP or DOWN to select Video Sound.
g) Press LEFT or RIGHT to select off or on.
h) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.
4.1.11 Set Interval
Press LEFT or RIGHT to decreases or increases the value by 5 second or 1 minute.
The following shows how to set triggering interval time to 5 Minutes provided
that the previous value is 1 Minute.
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Interval.
c) Press LEFT or RIGHT to decrease or increase to 5 Minutes.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.
4.1.12 Set PIR Sensitivity
It is recommended to use Normal mode. The following shows how to set PIR
sensitivity as Low provided that the previous option is Normal.
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Sense Level.
c) Press LEFT or RIGHT to select Low.
d) Press OK to save the current setting and the option will be un-highlighted.