HCO SG580M Manual - Manual (Page 17)

HCO ScoutGuard SG580M
4 Advanced Operations
Page 14
IP: (Max. 16 characters)
Port: (Max. 6 characters)
Account and Password :( Some telecom operators need to set account and password
to launch MMS.)
Number: (Max. 24 characters for each phone number)
Email: (Max. 48 characters for each email)
Please note that this is only an example, for more details please contact your network service
provider, and there are only 4 parameters needs to be edited, do pls not change other
parameters expect these 4 parameters to avoid operation failure.
4.1.16 Set MMS Mode
There are 3 MMS modes:“Manual”works in TEST mode，“Daily report”and
“Instant”work in ON mode.
The following shows how to set the MMS mode to Instant provided that the
previous option is Off:
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select MMS Mode.
c) Press LEFT or RIGHT to select Instant.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.
If you choose “Daily Report”, you need to set the daily report time: xxH, xxM.
If you choose “Instant”, you need to set how many MMS you want to send for
economy consideration. You can choose 0 to 99 pictures.
4.1.17 Set Send to
Enter the phone number or email which the MMS to be sent. The following
shows how to set sending to Number provided that the previous option is Email:
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Send To.
c) Press LEFT or RIGHT to select Number.
d) Press OK to enter into submenu.
Press MENU to cancel setting and return to info display
e) There are four inputs, press ﹟ to switch between each inputs. Press number
buttons to key in the digits, letters or punctuations. Press UP to delete.
f) Press OK to save all current setting and return to info display.
Press MENU to cancel setting and to return to previous menu.
4.1.18 Enter Password
If the password setting is selected as On, after switch on the camera, the LCD
screen on camera will prompt to enter password. The default password is 0000. Please
key in the password by using the remote control. It can be changed where the steps are
as following:
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Password.
c) Press LEFT or RIGHT to select On.