HF scientific Micro200BW Turbidimeter - 0-100 NTU - Manual (Page 26)

MICRO 200 BW 0-10 & 0-100 NTU (05/05)
Rev. 3.4
3.2.2 Main Menu
This is the main menu. It is the starting point for all sub-menu selections. Shown below are all function key selections and their
purpose.
Selection Options:
F1: Changes screen to SENSOR SETUP MENU
Select this option to:
Select sensor type
Select unit to display
Set digit suppression
Three point calibration
Adjust Offset Level
Full Scale Calibration
F2: Changes screen to ALARM SETUP MENU
Select this option to:
Set alarm limit
Set alarm mode
Select deadband
Flow alarm retention time
F3: Changes screen to DISPLAY PARAMETERS MENU
Select this option to:
Set screen brightness
Set upper/lower limits
Set time base
Set signal averaging
F4: Changes screen to MONITOR SETUP MENU
Select this option to:
Set time & date
Select D to A
Adjust Current/Voltage
Set serial port parameters
MAIN MENU
10NTU TURBIDITY
SENSOR SETUP...
ALARMS SETUP...
DISPLAY PARAMETERS...
MONITOR SETUP...
VER:M200NTUBW-8A23E
Menu
F1
F2
F3
F4
Page 14