HF scientific Micro200BW Turbidimeter - 0-100 NTU - Manual (Page 27)

MICRO 200 BW 0-10 & 0-100 NTU (05/05)
Rev. 3.4
Page 15
This is the Sensor Setup menu. As shown above, the cursor is highlighting 10 NTU Turbidity when you enter this menu. This
parameter can be changed to 100 NTU Turbidity or Backwash. Note: Backwash only functions if you purchased the optional
backwash hardware. To highlight the different parameters in the same row, use the "F" key to the left of the row you want to
change. When a parameter is highlighted with the cursor, it can be changed using the
keys.
By pressing in Sensor Setup. - Turbidity/Backwash
In this menu you can choose whether you want to display the Turbidity unit in NTU or
Backwash unit to %T. Use the keys to change it for your requirements.
By pressing in Sensor Setup menu. - Turbidity
In this menu you can suppress or hold the least significant digits to zero. Selections of 1
digit, 2 digits or none may be selected using the
key.
By pressing in Sensor Setup menu. - Turbidity
This is the turbidity calibration menu for the 0-10 NTU Range. The Cal point is highlighted,
but cannot be changed.
3.2.3 Sensor Setup - By Pressing from Main Menu
F2
F1
F1
NORMAL CAL
10NTU TURBIDITY
CAL POINT 1
∅.∅2∅∅NTU 237HZ
CAL POINT 2
4. ∅∅∅∅NTU 4114HZ
CAL POINT 3
1 ∅.∅∅∅∅NTU 97737HZ
OFFSET LEVEL
∅ ∅ ∅ ∅ ∅.∅∅∅∅ ∅∅∅∅ ∅∅∅∅ ∅∅∅∅ ∅∅∅∅
VER:M200NTUBW-8A23E
SENSOR SETUP
10NTU TURBIDITY
SENSOR
10NTU TURBIDITY NTU
DIGIT SUPPRESS
∅
NORMAL CAL...
FULL SCALE CAL...
VER:M200NTUBW-8A23E
SENSOR SETUP
BACKWASH
SENSOR
BACKWASH %T
DIGIT SUPPRESS
∅
NORMAL CAL...
FULL SCALE CAL...
VER:M200NTUBW-8A23E
SENSOR SETUP
10NTU TURBIDITY
SENSOR
10NTU TURBIDITY NTU
DIGIT SUPPRESS
∅
NORMAL CAL...
FULL SCALE CAL...
VER:M200NTUBW-8A23E
SENSOR SETUP
10NTU TURBIDITY
SENSOR
1
∅NTU TURBIDITY
NTU
DIGIT SUPPRESS
∅
NORMAL CAL...
FULL SCALE CAL...
VER:M200NTUBW-8A23E
F1
F2
F3
F4
Menu
F3