HF scientific Micro200BW Turbidimeter - 0-100 NTU - Manual (Page 32)

MICRO 200 BW 0-10 & 0-100 NTU (05/05)
Rev. 3.4
By pressing inside the Display Parameters menu. - Turbidity/Backwash
In this menu you can change the Signal Averaging period. Normally readings are updated
at a rate of once per second. A higher averaging time will give smoother curves to the
graphical display and to recording devices and helps "wash out" anomalies. Averaging
times of 15 sec., 30 sec, 60 sec. or OFF are available. Use the
keys to
change it for your requirements.
F4
By pressing inside the Display Parameters menu. - Backwash
In this menu the time base, which establishes the time increments on the measurement
graph can be highlighted, but there is only one time base available, 15MIN.
F3
3.2.5 Display Parameters - Continued
Page 20
VER:M200NTUBW-8A23E
DISPLAY PARAMETERS
BACKWASH
BRIGHTNESS
2 ∅
UPPER/LOWER LIMITS
1.∅∅ ∅.∅.∅
TIME BASE.
15MIN
SIGNAL AVERAGING
6 ∅ SEC
VER:M200NTUBW-8A23E
DISPLAY PARAMETERS
10NTU TURBIDITY
BRIGHTNESS
2 ∅
UPPER/LOWER LIMITS
1.∅∅ ∅.∅.∅
TIME BASE.
24HR
SIGNAL AVERAGING
6 ∅ SEC