Human Touch HT-5320 Massage Chair - Manual (Page 7)

humantouch.com
13
ENGLISH
Now choose a massage mode. Your Human Touch massage chair lets you
customize your massage using a wide variety of massage modes. Choose from
three stationary massage modes and a rolling massage, or combine them. Use
the Range button to tailor your vertical massage range, or the Zone and Position
buttons to target your massage to a specific area. Or, let the chair take control
– just select one of the three auto programs, which alternate between massage
modes and target different areas of your back. No matter how you use it, Human
Touch Technology
® offers maximum massage flexibility and refreshing benefits.
take control
Massage Programs massage the
specified area of your back for 15
minutes, using a variety of massage
techniques. The corresponding LED
lights on the remote to indicate which
massage mode is currently in use.
Full – Massages your
entire back
Upper – Focuses the massage on your
upper back
Low – Focuses the massage on your
lower back
Width — Focus or diffuse massage
pressure by selecting the wide, standard,
or narrow width setting. Select the width
setting after selecting percussion or
rolling massage modes.
Stretch — Press and hold the Stretch
button until the remote beeps twice (may
take up to 15 seconds). The chair performs
a gentle upper-body stretch.
Position (up/down arrows) — Use this
button along with any stationary massage
mode, to target the massage to the
desired area of your back. You can press
this button before or after selecting the
massage mode.
Calf Kneading — Activates a kneading
calf massage. Press to toggle among two
speeds and an auto massage program.
Power — Lights to indicate that
master power switch is on.
Position Controller
To select a position setting, use your
thumb to move the controller in the
direction of the desired setting.
Legs up — Raises the foot and calf
massager to a horizontal position.
Legs down — Lowers the foot and calf
massager to a vertical position.
Back down — Reclines the backrest to a
horizontal position.
Back up — Raises the backrest to a
vertical position.
When you’re not using the remote, store it
in the convenient pocket on the left-hand
side of the chair, so it’s out of the way.
End — Stops the massage.
Range — Customizes your vertical
massage range.
Stop — Stops the massage and parks
the massage rollers at the top of the
backrest.
Arm/Thigh — Activates the arm/thigh massage.
Customize the automatic programs using
these buttons to selectively subtract specific
massage functions from each program.
You can replace any subtracted program
by pushing the appropriate button again.
The automatic programs reset to include
these massage functions after your massage
session ends.
Seat – Subtracts the Seat Massage.
Calf Knead – Subtracts the Calf Kneading.
Foot – Subtracts the Foot Vibration.
Zone — Targets your massage to
a six-inch zone. Use the Position
buttons to focus your massage on the
desired area.
Seat (Air Impulse Massage Seat) — Activates
the unique seat massage.
Foot Vibration — Activates the foot vibration.
SIDE
FRONT
When changing backrest or foot and calf
massager direction, there is a slight pause
while the chair gears shift. This is perfectly
normal.
Manual Massage Techniques — Four
manual massage techniques let
you customize your massage. Each
massage technique button (except
rolling) toggles among auto (alternates
speeds), high and low speeds.
See page 14 for more information about
manual massage techniques.
Your Human Touch massage chair features
automatic Acupoint detection — This
feature detects your accupressure points
before beginning an auto massage program,
then tailors your massage accordingly.
The Acupoint LED lights during Acupoint
detection.
12