Moving the range, Completing the move – La Cornue CornuFé 44 User Manual

Page 25

Advertising

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

Fig.7-4

Fig.7-5

Fig.7-6

Moving the Range

The range is very heavy. Take great care.

On no account try and move the range while it is

plugged into the electricity or gas supply.

We recommend two people maneuver the range. Make sure

that the floor covering is firmly attached, or removed to

prevent it being disturbed when moving the range around.
To help you, there are two levelling rollers at the back, and

two screw-down leveling feet at the front.
Remove the polystyrene base pack. From the front, tilt the

range backwards and remove the front half of the polystyrene

base.
Repeat from the back and remove the rear half of the

polystyrene base.

Removing the Storage Drawer

Pull the drawer right out.
Push the ends of the plastic clips – down of the left-hand side,

up on the right-hand side – to release the catches holding the

drawer to the side rails (Fig.7-4). At the same time pull the

drawer forwards and away from the side rails.
For safety reasons slide the inner side rails back into the

cavity.
Put the drawer somewhere safe – do not replace it until you

have completed the installation, you will need access to the

area behind the drawer.

Lowering the Two Rear Rollers

To adjust the height of the rear of the range, first fit a 13 mm

spanner or socket wrench onto the hexagonal adjusting

nut (Fig.7-5). Rotate the nut – clockwise to raise – counter-

clockwise to lower.
Make 10 complete (360°) turns clockwise. Make sure you

lower BOTH REAR ROLLERS.

Completing the Move

Unfold the rear edge of the cardboard base tray. Get a good

grip on the top of the oven cavity panel as you move the

oven. Carefully push the range backwards off the cardboard

base. Remove the base tray.
Position the range close to its final position, leaving just

enough space to get behind it (Fig.7-6).
Do not replace the storage drawer yet.
IMPORTANT: Remove all tape and packaging. Make sure

the burner heads are properly seated and level. Take the

accessory pack out of the oven. Check to be sure that no

range parts have come loose during shipping.

Advertising