La Cornue AlberTine 36 - Manual (Page 12)

10
ArtNo.320-0023
Oven light USA
To remove and refit the racks
The rack has a small kink on either side (Fig.2-20). To remove
the rack, line these up with the stops in the rack support
(Fig.2-21). Lift the rack upwards so that it will pass over the
rack stop and then pull it forwards (Fig.2-22).
Refit in the reverse order, making sure to push it fully back.
To remove and refit the telescopic rack and runners
Slide the rack out on the runners. While holding one of the
runners securely, carefully lift the rear of the rack upwards:
the rack will spring clear of the central restraining tab. Repeat
for the opposite side of the rack.
Note: To aid the removal of the shelf you can insert a suitable
flat tool through the opening in the side of the runners and
lever the rack clear (Fig.2-23).
Tilt the front of the rack downwards and then lift clear of the
runners (Fig.2-24).
Refit in the reverse order, making sure to push the rack down
onto the runner arms.
Oven Light
Press the appropriate button to turn on the oven lights.
If one of the oven lights fail, turn off the range circuit breaker
before you change the bulb. See the ‘Troubleshooting’ section
for details on how to change an oven light bulb (Fig.2-25).
Fig.2-20
Fig.2-25
Fig.2-21
Fig.2-22
Fig.2-23
Fig.2-24