La Cornue AlberTine 36 - Manual (Page 32)

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
30
ArtNo.280-0045 Burner Knob
Seal the Openings
Seal any openings in the wall behind the range and in the
floor under the range when hookups are completed.
IMPORTANT: When all connections are completed make
sure the flow of combustion and ventilation air to the range
is unobstructed.
Assemble the Range
Installing the Control Knobs
The range is supplied with 5 burner control knobs. These are
for the gas controls to the left of the control panel (Fig.6-33).
There are also 2 oven control knobs (Fig.6-34).
Push the multi-function oven selector knob and temperature
knob on to the control spindles at the right hand side of the
control panel.
Installing the Handrail
Components (Fig.6-35)
Hand rail tube
1
End cap with Allen fixing screw 2
Plastic friction cup 2
Hold a friction cup by the tabs on one end of the tube
(Fig.6-36).
Line up one of the end caps to the tube and push it on the
tube over the friction cup (Fig.6-37).
Turn the tube over and push on the other end cap using the
second friction cup, making sure that you do not scratch or
damage the first end piece and the that the two end pieces
are lined up correctly.
Install the assembled handrail on the projecting mounting
studs on the control panel and hold it in place by tightening
the Allen screws. The Allen screws should be on the underside
(Fig.6-38).
Installing the Door Handle
Assemble the door knob to the door knob base and screw it
to the mounting on the oven door. Hand tighten only – do
not use any tools (Fig.6-39).
Installing the Toe Kick
Remove the 3 screws for the toe kick mounts along the front
bottom edge of the range. Fasten the toe kick using these
screws (alternative color screws can be found in the loose
parts pack).
ArtNo.280-0053 Door Knob Screw to Door
Fig.6-39
ArtNo.280-0047 Oven Knob
Fig.6-34
Fig.6-35
Fig.6-36 Fig.6-37
Fig.6-38
Fig.6-33