SONIQ CWR300ND - Manual (Page 80)

- 78 -
The following table describes the parameters and buttons of this page:
Field Description
Direction Select
Select the router interface. You can select LAN or
WAN. In this example, WAN is selected.
WAN Setting You can choose Interface or IP Address.
WAN Interface
Choose the interface that permits data packets from
WAN to access the router.
IP Address
Enter the IP address on the WAN. Only the IP
address that is in the same network segment with
the IP address on the WAN can access the router.
Services Allowed
You can choose the following services from WAN:
Web, Telnet, FTP, TFTP, SNMP, or PING. You can
also choose all the services.
Add
After setting the parameters, click it to add an entry
to the Current ACL Table.
Reset Click it to refresh this page.
3.6 Advance
In the navigation bar, click Advance. In the Advance page that is displayed
contains Bridge Setting, Routing, Port Mapping, QoS, SNMP and Others.
3.6.1 Bridge Setting
Choose Advance > Bridge Setting, the page shown in the following figure
appears. This page is used to configure the bridge parameters. You can change
the settings or view some information on the bridge and its attached ports.