SONIQ CWR300ND - Manual (Page 82)

- 80 -
3.6.2 Routing
Choose Advance > Routing, the page shown in the following figure appears. The
page that is displayed contains Static Route and RIP.
3.6.2.1 Static Route
Click Static Route in the left pane, the page shown in the following figure appears.
This page is used to configure the routing information. You can add or delete IP
routes.
The following table describes the parameters and buttons of this page:
Field Description
Enable Select it to use static IP routes.
Destination Enter the IP address of the destination device.
Subnet Mask Enter the subnet mask of the destination device.
Next Hop Enter the IP address of the next hop in the IP route to the
destination device.
Metric The metric cost for the destination.