Stealth Cam STC-I840IR Rogue-IR - Manual (Page 28)

STC-I840IR
www.stealthcam.net Toll Free 877-269-8490
28
Using the Camera in PIR Detection Mode

Mount the camera to a tree or other sturdy object using either
the supplied mounting strap. (Please refer to the mounting
suggestions section in this manual)

Open the front housing and slide the Toggle switch from OFF
to TEST position. You will hear two short consecutive beeps
followed by a third beep.

Move the switch from Test to ON position to activate your PIR
mode.
 The camera’s green LED light will begin blinking and enter
count down mode. This is your indication to leave the coverage
area within one minute.

After one minute, the camera will take between 1~9 pictures, or
AVI video clip based on your program settings. The camera will
then time out between 1~60 minutes also based on your
selection.
 The time between motion detection and the camera taking
pictures may vary due to lighting and environment
conditions, program settings and battery power level.