Cutmaster a120 – Tweco A120 CutMaster User Manual
Page 16
CUTMASTER A120
INTRODUCTION
Manual 0-4989
2-2
2.04 Power Supply Specifications
CutMaster A120 Power Supply Specifications
Input Power
208 / 230 VAC (187 - 253 VAC), Single Phase, 60 Hz
230 VAC (187 - 253 VAC), Three Phase, 50/60 Hz
380 VAC (360 - 440 VAC), Three Phase, 50/60 Hz
400 VAC (360 - 440 VAC), Three Phase, 50 Hz
460 VAC (414 - 506 VAC), Single Phase, 60 Hz
460 VAC (414 - 506 VAC), Three Phase, 60 Hz
600 VAC (540 - 630), Three Phase, 60 Hz
Input Power Cable
Power Supply includes input cable.
Output Current
30 - 120 Amps, Continuously Adjustable
Power Supply Gas Filtering Ability
Particulates to 5 Microns
CutMaster A120 Power Supply Duty Cycle *
Ambient Temperature
Duty Cycle Ratings @ 40° C (104° F)
Operating Range 0° - 50° C
All Units
Duty Cycle
**60%
80%
100%
Current
120
120
100
IEC
IEC
IEC
DC Voltage
128
128
120
* NOTE: The duty cycle will be reduced if the primary input power (AC) is low or the output voltage
(DC) is higher than shown in this chart.
** 60% at 208/230V 1-Phase Input ONLY
NOTE
IEC Rating is determined as specified by the International Electro-Technical Commission. These specifications include
calculating an output voltage based upon power supply rated current. To facilitate comparison between power sup-
plies, all manufacturers use this output voltage to determine duty cycle.
Power Supply Dimensions & Weight
Ventilation Clearance Requirements
26.3"
0.668 m
63 lb / 28.6 kg
10"
254 mm
13.78"
350 mm
Art # A-08459
6"
150 mm
24"
610 mm
6"
150 mm
6"
150 mm
Art # A-07925_AB