Tweco GCM-6000 Gas Control - Manual (Page 18)

INSTALLATION PROCEDURES 12 Manual 0-2641
A-01794
Rear Panel
Rear Panel
Screws (4 Places)
Figure3-1 Rear Panel Removal
3. Remove the eight screws securing the Right and
Left Side Panels to the unit.
A-01802
Right Side Panel
Screws (4 Places)
Left Side Panel
Screws (4 Places)
Figure 3-2 Side Panel Screw Removal
4. Pull the two Side Panels out the back of the unit.
A-01803
Side Panel
(Right)
Side Panel
(Left)
Figure 3-3 Side Panel Removal
5. Select a flat, horizontal, mounting surface for the
unit.
6. Using the full size template on the last page of this
Manual mark the location of the four mounting
holes.
7. Drill four 9/32 inch holes at the marked locations.
6. Mount the unit to the surface using four 1/4-20
bolts, lock washers and flat washers provided. For
convenience two different lenghts have been pro-
vided (3/4 and 1-1/2 inches).
NOTE
There are four holes provided in the base of the Gas
Control Module. Use only these four holes for
mounting the unit.
1/4" Mounting Bolts,
Lock Washers and
Flat Washers (4 Places)
A-01804
Figure 3-4 Mounting Hardware Installation