07 input power cable connections, 07 input power cable connections -4, A. primary power cable connection procedure – Tweco 1000 Merlin(Dec2004) User Manual
Page 22
INSTALLATION
3-4
Manual 0-2708
7. Reinstall the star washers and nuts.
8. Tighten all the nuts.
NOTE
If changing from low voltage to HIGH VOLTAGE
all nuts must be tightened even if not used on the
terminal block.
9. Insert the single wire voltage selection plug into the
auxiliary transformer input connector.
Auxilliary Transformer
Input Connector
Voltage
Selection
Plug
Terminal
Block
Voltage Selection
Block
A-02071
SEE OPERA TING MANU
AL FOR
INST ALLA
TION INSTRUCTIONS
A
UX.
TRANS
.
HIGH VO
L TA
GE
208V/230V
Nuts and Star Washers
Figure 3-3 Low Voltage Configuration
3.07 Input Power Cable
Connections
WARNING
Disconnect primary power at the source before con-
necting the primary power cable to the power sup-
ply.
The primary power cable must be supplied by the end
user and installed to the power supply assembly. Refer
to Appendix 1 for suggested cable sizes.
A. Primary Power Cable Connection
Procedure
1. Route the primary power cable through the strain re-
lief fitting in the rear panel of the power supply and
tighten strain relief screws.
AC Input Cable
Strain Relief
AC Input
Power Cable
A-02159
Figure 3-4 AC Input Power Cable Strain Relief